Send Email
Send SMS
Betala Tarpaulin Company
Betala Tarpaulin Company

Tar fit Sheet

Pioneers in the industry, we offer tarfit sheet from India.

Tarfit Sheet


Tarfit Sheet
Ask for Price

Thanks for Contacting Us.

Polymeric Plastifelt is a waterproofing membrane composed of a high density polyethylene core covered on both sides with polymeric, plasto elasto bitumen based on APP/SBS and other selected polymers, constituting a (triple) continuous and flexible water proofing layer.

Easy application and adaptability to the roof
Plasto elastic
Roof movement absorption
Flexibility at very low temperature
High temperature resistance
Practically no aging


Technical Data
Polymeric Bitumen
Softening Point
Penetration at 25 degree C 100g. 5 Sec.
Exceeding 125º C
50 1/10 mm + 8
Core High Density Polyethylene film
Thickness 0.10 mm + 0.01 mm
Covering Plastic 2 Polyethylene films with a normal thickness of 0.01 mm
Mechanical strength of the membrane
Tensile test
Break Load - lenghtwise / cross wise
Elongation at break
140 N/5cm
120 N/5cm
300% in both directions
Heat resistance
10 x 10 cm test pieces hung vertically
during 2 hours at 100ºC
Does not drip
Cold resistance - Pliability Does not crack at ºC

The rolls must be stored horizontally and parallel (not crossed) and never stacked more than 6 roofs high. The membranes must always be stored protected against weathering.

--> Waterproofing of roofs trafficable and non trafficable, both traditional and inverted.
--> Waterproofing of foundations, basements and underground jobs.
--> Waterproofing of swimming pools, tanks, and reservoirs.

Instruction for Use
In general, the usual procedures for continuous water proofing are followed, and application should be carried out by specialized personnel.

Application System
Polymeric Plastifelt can be applied either fully bonded or loose laid, depending on the protection and slope.

Polymeric Plastifelt is applied torched on, using a propane or butane gas torch.

The substrate receiving the polymeric plastifelt membrane must be firm, dry, clean and free from badly adhered materials. It must also be even and smooth, without any elements that should damage the membrane.

Application of the Membrane
To adhere the membrane to the surface of the substrate three procedures can be used

--> Loose laid
--> Preming with asphaltic paint, and then flame bonding.
--> Hot polymeric bitumer.


Yes! I am Interested


Explore More Products

Contact via E-mail
Contact via SMS
Betala Tarpaulin Company
Rahul Betala (Proprietor)
No. 1, Kalathi Pillai Street, Sowcarpet ,
Chennai - 600079, Tamil Nadu, India
Call Us: 
Call Response Rate: 89%
Share Us :

Home  |   About Us   |  Our Products  |  Site Map  |   Contact Us   |   Mobile Site

© Betala Tarpaulin Company. All Rights Reserved (Terms of Use)
Developed and Managed by IndiaMART InterMESH Limited

Betala Tarpaulin Company